Blow out the dust from the print module compartment

WHAT YOU NEED 

Tools:Allen Key SetAir Gun

Safety Equipment:Standard Personal Protective Equipment

  1. Isolate the saw electrically.
  2. Lift the printer cover.
  3. Remove the print module cover.
  4. Visually inspect the print modules for any signs of damage.
  5. Blow air towards the ground for several seconds to make sure there is no moisture left in the air gun.

  6. Carefully blow out any dust or dirt from the print module compartment.

    CAUTIONDo not blow sustained air pressure directly onto the print modules.

  7. Refit the print module cover.
  8. Close the printer cover.
  9. Turn on the electrical isolation switch on the front of the saw.